top of page

Embossing

Manual Embossing WB_edited.jpg

GMS - 200

  • 220-volt operation

  • Electronic temperature regulator

  • Embossing die size 50mm x 100mm

  • Table size 150mm x 150mm

  • Manual lever operated with self-lock system

  • Fine adjuster for impression depth control

Manual Embossing

​

GMS - 201

  • Electronic temperature controller

  • Pressure controlled by air regulator

  • Mechanical stopper for impression depth

  • Digital process time controller

  • 220-volt operation

  • Footswitch operated

Embossing-Light Duty

​

Economy Embossing WB_edited.jpg
Embossing WB_edited.jpg

GMS - 202

Embossing-0.5 Ton

  • Digital temperature regulator

  • Digital process time controller

  • Fine adjuster for impression depth control

  • Table size 250mm x 250mm

  • To make operations easier The die-fixing block can be turned 90°

  • Pressure adjustment with an air regulator

GMS - 203

Pillar Embossing

  • Removable tray provided with a table to accommodate bigger panel

  • Pressure adjustment with an air regulator

  • Digital temperature regulator

  • Digital process time controller

  • Fine adjuster for impression depth control

  • Deep throat from die block is 250mm

  • Tabletop version

  • 220-volt operated

  • Maximum die accommodation size:50mmx100mm

Pillar Embossing WB_edited.jpg
Pedestal Embossing WB_edited.jpg

GMS - 205

Pedestal Embossing

  • Pedestal version for embossing finished bags without interference

  • Pressure adjustment with an air regulator

  • Digital temperature regulator

  • Digital process time controller

  • Fine adjuster for impression depth control

  • Maximum die accommodation size:50mmx100mm

  • 220-volt operation

  • Foot pedal operated

HYDRAULIC-EMBOSSING-WB.gif
CUT-CUM-EMBOSS-WB_edited.jpg

GMS - 207

  • Table Size;A4 (210mm x 300mm)

  • 415 volt operated

  • Rigid construction

  • Hydraulic version

  • Regulator for pressure control with gauge

  • Electronic control for process time

  • Mechanical stopper to control Embossing depth

  • Kiss cutting concept to minimise noise level and no impact effect on shop floor

  • Heater power : 1650 watt

  • Mechanical depth adjuster accuracy : 0.025mm

  • Parallelism adjuster for top and bottom die fixing plate

  • APPLICATION:

  • Embossing upto A4 size

  • Cut cum emboss (hard tool)

  • For recutting dies with safety bushes

  • Tussel Cutting

  • Clicking dies with fibre board

  • Vamp Perforation

Cut and Emboss

GMS - 209

Hydraulic Embossing - 500x500

  • Rigid construction

  • Table size :500*500 mm

  • Hydraulic operated

  • 415 volts

  • Regulator for pressure control

  • Electronic controller for process time

  • Mechanical stopper to control embossing depth

  •  

  • APPLICATION:

  • For cutting, debossing, plating and flat pressing of weaved component

bottom of page